![]() *If your unit does not power up from the USB, you will need to update in the car, and apply car power at step 4. You will need the micro USB cable that shipped with your Bump Box. Menu Bar, Then click “Program” to Update. In the USB Updater Screen, click “Program” in the (DavisTech_UPD.exe located in the unzipped folder)ĩ. Once the computer is ready, run the update file. The Computer should now recognize the USB Device.Ĩ. Release the “Test” button, LED will Flash Yellow.ħ. The LED will flash alternating Green/Red, Then Red.Ħ. Set the right hand knob (Pulse/Fine) to 9.Ĥ. (You will need the serial number from the back of the unit to determine the correct file)Ģ. Download and Unzip the firmware file for your unit. Updating the firmware is simple, just follow the steps below.ġ. The Bump is easily adjustable with two dials on the face of the unit. The BB-300 interrupts the negative battery voltage signal to the solenoid to allow for precise movement when the Bump Button is pressed. (Example– one blink, followed by a pause, then 3 consecutive blinks= 1.3) Davis Technologies Bump BoxThe BB-300The BB-300 is used on trans brakes that have the ground wire of the solenoid available to the user, also known as a 2 Wire Solenoid. After 5 seconds the LED will turn off, then begin blinking out the firmware. Note- To check which version of firmware you currently have, follow these steps.Ģ. It is recommended that all users upgrade, as the over all functionality is different (New Operating Instructions) than the previous versions, and having all units in the field operating on the same firmware not only aids when comparing notes with other racers, it also allows for more efficient tech support if needed. This new firmware will allow more tune ability by the user to achieve more precise control over the car when “bumping In”. * The serial Number is engraved on the back below the manufacture date Serial numbers lower than 2127 should be updated. Serial numbers 2127 and higher already have version 1.5 There is a small chance that the hardware could be rendered unusable, requiring a quick-turnaround service to Davis Technologies. It is NOT recommended to update your system immediately before a race/test weekend. We recommend that you allow time for testing and setup after download.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |